DIY Projects

Restore Your Vacuum's Suction

I just spent $16 on a used upright vacuum cleaner. Right now it sucks up dirt about as fast as a baby sea turtle can drag itself to the ocean -- that is, painstakingly slowly. So why did I buy it? Answer: it's not broken. It just needs some TLC in the form of a new drive belt.
 
Replacing the drive belt on a vacuum cleaner is an easy DIY repair that anyone can do. The drive belt is just a big old rubber band. One end of the belt hooks around a shaft that's attached to the vacuum's motor. The other end hooks around the vacuum's rotating brush, which sweeps the floor and scoops up all the crumbs, hair and other crud you're trying to get rid of. Above is a photo of my "new-old" vacuum cleaner with the drive belt removed and displayed on top, so you can see what it looks like.
 
Is your vacuum short on suction? First eliminate other possible causes: check for blockages and leaks in the tubes, and obstructions or tangles in the rotating brush. This sort of thing comes under the category of regular maintenance that you should be doing every now and then anyway. If none of those things is the cause, then you should replace the drive belt.
 
First, you'll need a replacement belt. Carefully note down your vacuum's model number. If you're lucky, the manufacturer will have cut you a break and displayed the bag and belt type very clearly on the exterior casing of the vacuum. That way you won't have to go searching for the manual each time you need replacements. (Argh! Don't you hate that?) Parts can be ordered online at the manufacturer's site, at other spare parts sites, or in hardware and home goods stores. They don't cost much. A few bucks, tops.
 
Second, unplug your cleaner and flip it over so the rotating brush is exposed. With a screwdriver, remove the screws covering the plastic guard plate that surrounds the brush. When that's off, you should be able to see the belt.
 
Here's how you'll know the belt needs replacing:
1) Test it with your finger. It should be nice and tight. If there's any slack, replace it.
2) How old is it? Manufacturers recommend that belts be replaced every few months.
 
The rest is pretty straightforward. Install the new belt. You may need to exert a little force to get it in the correct position. Then reattach the cover plate using your screwdriver. That's it! You're done! Congratulations, friend. You just extended the life of your vacuum cleaner.
 
Photo Credit: Getty Images

Newsletter Signup
  • Connect
  • Pinterest

Terms of Service | Privacy Policy Corporate Site | Advertise With Us | About Our Ads

Copyright © 2014 Homesessive | All Rights Reserved | Part of AOL-HuffPost Home